ST-02 Speed Gate Increased Sliding Panels
ST-02 Speed gate with sliding panels provides an ideal contactless solution for access control and comfortable passage in an intense flow of people, avoiding queues at the entrance and exit.
• two posts with built-in electronics
• two sliding panels made of tempered glass
• remote control panel
ST-02 Speed gate is available in two versions: with a standard passageway width of 600 mm and increased one of 900 mm.
Sliding panels will open upon receipt of authorization signal.
STD-02 central sections can be installed in order to increase the number of passage lanes. The tracking system is equipped with two levels of infrared sensors: 30 pairs are located on the upper level and 30 – on the lower level, which guarantees passage security at high throughput rate and provides protection from tailgating.
In case of power loss, the sliding panels will unblock.
Indication blocks of the passage direction are located on the turnstile front ends. The turnstile mode indication blocks (open/closed) are located on the top covers.
There is a possibility to install readers under the post covers.
The turnstile can operate both in standalone mode, from the remote control panel or wireless control device, or as a part of access control system. The remote control panel is included in the standard delivery set.
It is suggested to use a special ST02_Children firmware if ST-02 speed gates are used in children facilities. Kindly contact PERCo technical support department to get the firmware and instructions about its update.
Operating voltage: 24 V DC
Power consumption: 204 W
Consumption current: 8.5 A
Number of passage directions: 2
Throughput rate (in the single passage mode): 60 persons/min
Dimensions (length×width×height): 1923×1963×1428 mm
Passageway width: 900 mm
Operating temperature range: from +1 °C to +50 °C
IP Code: IP41
The required operating range of the readers: min 40 mm
Overall ACS-controller dimensions: max 160×140×40 mm
Overall installed readers dimensions: max 230×72×32 mm